![]() ![]() Shake / wooble faulty brake axis cable near the connector and watch the signal while doing so ( DIVIEW software is more handy to watch signal). and use contact spreay if you have one.Ģ. In any case.blow off your contacts and test again. In this step you determine what is to blame - cable or electronics. IF problem is in the cable it will follow cable now and change axis.but if electronics have issue the problem WILL STAY on same axis regardless of cable being swapped. In essence your left brake will now become Y axis, and right brake will be X axis. Swap left and right brake cable connection to main electronics. In fact, it should NEVER reach 0 or 100% signal on axis. In this mode you will have a working signal regardless of angle adjusted and calibration, troughout the range.but it will not be full from 0 to 100%. ![]() This is basically sensor inspection mode. You can inspect brake axis by turning off (untick) autocalibration ON/OFF feature on X and Y axis (called "service mode since v.2.17) and click apply. This happen very rarely so make sure you read all other brake axis FAQ topics first ! In that case it is necessary to swap brake shaft's and re-calibrate to make it work again Faulty brake axis cable- test and replace brakes will not work or will work but very poorly/jittery. to replace brake springs and by mistake put left shaft in place of right brake shaft and vice versa. Faulty brake axis cable or electronics.read FAQ for thatĦ. If you experience that you need to recalibrate often this is usually the cause so tighten these screws better.ĥ. ![]() Sometimes, if you did not tighten footrests angle adjustment screws enough, angle of the pedals can change due to pressure of your heel, and therefore calibration will be wrong. If using Manual Calibration and you readjusted the angle of the footrests then it is mandatory to CALIBRATE brake axis INSIDE MFG CONFIGURATOR softwareĤ. Try to unplugg them and then replugg them and check if problem is solvedģ. Check that brake axis cables are firmly plugged in. If this is working fine from 0 to 100% then read on other FAQ topic regarding windows calibration and in game settingsĢ. Always verify working of brakes in MFG Configurator software. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |